Aquastop Nanosil waterproofing pack
Kerakoll's own picture of Aquastop Nanosil.

Kerakoll WaterproofingNo. 15 / 19

Aquastop Nanosil Technical Data Sheet (TDS)

Neutral, silane waterproof sealant

Aquastop Nanosil is a neutral silane waterproof sealant in a 290 ml cartridge, so it is gun applied pointing material rather than anything that covers an area. Neutral cure matters because an acid curing sealant can stain natural stone and attack some metals, which is exactly where a waterproofing detail tends to end up.

  • Sanitary joints in bathrooms and wet areas
  • Movement joints finished after waterproofing
  • Sealing around trays, thresholds and penetrations
  • Joints against natural stone where neutral cure is needed
Data sheet0.2 MB

Build a list across products and send it once, or ask about Aquastop Nanosil on WhatsApp now.

Consumption
25 ml per metre of 5 by 5 mm joint
Pack we stock
290 ml cartridge
Colour
Grey thixotropic paste

About Aquastop Nanosil

Use it for the sanitary and movement joints that finish a wet area, around trays, thresholds and penetrations, after the membrane and the tapes have done the waterproofing. Shelf life is 18 months. Order cartridges against the measured length of joint rather than by floor area, and treat it as a finishing item: it seals a gap, and it replaces neither Aquastop Nanoflex, Aquastop Flex nor an Aquastop tape anywhere in the system.

Documentation

Related documentation

  • Technical data sheet

    0.2 MB · PDF

    Aquastop Nanosil as the manufacturer publishes it, unaltered.

    Download
  • Safety data sheet

    Needed for a method statement or a site file. Ask and we will send it.

    Request
  • Submittal pack

    Data sheet, safety data sheet and our authorisation letter together, for a consultant submittal.

    Request

Coverage calculator

How much you need.

m
mm
mm

The sheet pairs 5 mm deep with a 5 mm joint.

As published in the data sheet

250ml

  • Joint of rectangular section, as printed, 5 mm wide by 5 mm deep
  • 25 ml per metre
  • over 10 m of joint

Order 1 pack of 290 ml cartridge

Send this quantity for a quote

Taken from the Aquastop Nanosil data sheet: Coverage: approx. 10 m (joint 5x5 mm) with 1 cartridge (290 ml). Joint minimum width 5 mm, joint maximum width 25 mm. No site allowance is added unless you turn one on. The sheet prints approximately 10 metres from a 290 ml cartridge at a 5 by 5 mm bead, which is about 14 percent more material than the section arithmetic gives. The calculator uses the section, so order on the printed figure for a long run.

Application

Where it is used.

  1. 01Sanitary joints in bathrooms and wet areas
  2. 02Movement joints finished after waterproofing
  3. 03Sealing around trays, thresholds and penetrations
  4. 04Joints against natural stone where neutral cure is needed

Specification

Technical data.

  • EN 14891
Aquastop Nanosil technical specifications from the manufacturer TDS
Pack size290 ml cartridge
ColoursGrey thixotropic paste
Application temperature+5 deg C to +40 deg C
ConsistencyGrey thixotropic paste
Storage and shelf life18 months
Product typeNeutral, silane waterproof sealant

Typical values as Kerakoll prints them in the data sheet for Aquastop Nanosil. Manufacturers revise their sheets, so ask us for the current edition before you specify.

On site

Packs, mixing and storage.

We stock

290 ml cartridge. Other pack sizes can usually be brought in on a project order, so tell us the quantity before you assume what is available.

Storage

18 months in unopened packaging, stored dry and out of direct sun. Heat and humidity both shorten it.

For quantity surveyors

BOQ clause.

Supply and apply Aquastop Nanosil, a waterproofing manufactured by Kerakoll. Neutral, silane waterproof sealant. Allow 25 ml per metre of 5 by 5 mm joint, as published by the manufacturer. Supplied in 290 ml cartridge. Prepare the substrate and apply strictly in accordance with the manufacturer's current technical data sheet. Rates are for estimating and exclude wastage.

Schedule fields for Aquastop Nanosil
ProductAquastop Nanosil
ManufacturerKerakoll
TypeWaterproofing
Consumption25 ml per metre of 5 by 5 mm joint
Pack size290 ml cartridge
Unit of measurementm2

Frequently Asked Questions

290 ml cartridge

You can download the official Aquastop Nanosil technical data sheet as a PDF directly from this page, sourced from the manufacturer. For prices and stock in the UAE, contact Lapiz Blue on WhatsApp.

Aquastop Nanosil in the UAE

Tell us the area. We will quote the job.

Lapiz Blue supplies Kerakoll from Dubai, Abu Dhabi and Sharjah. Send the quantity of Aquastop Nanosil you need, or describe the job and we will work it out with you.

Chat on WhatsApp