
Mapei Surface TreatmentNo. 31 / 54
Ultracare 5 Sides Sealer Technical Data Sheet (TDS)
Mapei surface treatment.
Applied before the tile goes down rather than after, UltraCare 5 Sides Sealer is a water based treatment for the back and four edges of a slab, intended to stop surface efflorescence and staining driven by rising damp. That timing is the whole point of it.
- Back and edge sealing before laying
- Absorbent natural stone and slabs
- Preventing surface efflorescence
- Protection against rising damp staining
- Natural look finish with no colour change
Build a list across products and send it once, or ask about Ultracare 5 Sides Sealer on WhatsApp now.
- Consumption
- 0.067 to 0.1 L/m²
- Pack we stock
- 5 kg
- Colour
- transparent
Mapei document 00432 · revision 11-2025
About Ultracare 5 Sides Sealer
The UltraCare stain protectors treat the visible face once a floor is finished, while this one seals the faces nobody can reach again. It is the choice where a screed or slab will carry moisture and salts into an absorbent stone, a common story in UAE ground floor and landscaped areas. The finish is a natural look, with no change to how the material reads. Coverage runs at one litre per 10 to 15 square metres from a 5 kg pack, applied between 5 and 40 degrees and stored for 12 months.
Documentation
Related documentation
Technical data sheet
Revision 11-2025 · 1.9 MB · PDF
Ultracare 5 Sides Sealer as the manufacturer publishes it, unaltered.
DownloadSafety data sheet
Needed for a method statement or a site file. Ask and we will send it.
RequestSubmittal pack
Data sheet, safety data sheet and our authorisation letter together, for a consultant submittal.
Request
Coverage calculator
How much you need.
As published in the data sheet
3.35 to 5.00litres
- Per coat, any substrate: 0.067 to 0.1 litre/m2
- over 50 m2
Order 1 to 2 packs of 4.8 litre 5 kg drum, equivalent to 4.8 litres
Taken from the Ultracare 5 Sides Sealer data sheet: CONSUMPTION: 1 L per 10-15 m2. No site allowance is added unless you turn one on. The sheet publishes an area per litre, which is inverted here into litres per square metre. It then says consumption will vary significantly with density, porosity, texture, surface absorption, weather, application method and the number of coats, and it does not say how many coats. The drum is sold by weight, 5 kg, and holds 4.8 litres.
Application
Where it is used.
- 01Back and edge sealing before laying
- 02Absorbent natural stone and slabs
- 03Preventing surface efflorescence
- 04Protection against rising damp staining
- 05Natural look finish with no colour change
Specification
Technical data.
| Coverage | 1 L per 10-15 m². Consumption will vary significantly depending on density, porosity, texture, surface absorption, weather conditions, application method, and the number of coats. |
|---|---|
| Pack size | 5 kg |
| Colours | transparent |
| Application temperature | From +5°C to +40°C |
| Consistency | liquid |
| Storage and shelf life | UltraCare 5-Sides Sealer can be stored for up to 12 months in its original packaging. |
Typical values as Mapei prints them in the data sheet for Ultracare 5 Sides Sealer. Manufacturers revise their sheets, so ask us for the current edition before you specify.
On site
Packs, mixing and storage.
We stock
5 kg. Other pack sizes can usually be brought in on a project order, so tell us the quantity before you assume what is available.
Storage
UltraCare 5-Sides Sealer can be stored for up to 12 months in its original packaging. in unopened packaging, stored dry and out of direct sun. Heat and humidity both shorten it.
For quantity surveyors
BOQ clause.
Supply and apply Ultracare 5 Sides Sealer, a surface treatment manufactured by Mapei. Allow 0.067 to 0.1 L/m2, as published by the manufacturer. Supplied in 5 kg. Prepare the substrate and apply strictly in accordance with the manufacturer's current technical data sheet. Rates are for estimating and exclude wastage.
| Product | Ultracare 5 Sides Sealer |
|---|---|
| Manufacturer | Mapei |
| Type | Surface Treatment |
| Consumption | 0.067 to 0.1 L/m2 |
| Pack size | 5 kg |
| Unit of measurement | m2 |
Frequently Asked Questions
As per the TDS: 1 L per 10-15 m². Consumption will vary significantly depending on density, porosity, texture, surface absorption, weather conditions, application method, and the number of coats.
5 kg
You can download the official Ultracare 5 Sides Sealer technical data sheet as a PDF directly from this page, revision 11-2025, sourced from the manufacturer. For prices and stock in the UAE, contact Lapiz Blue on WhatsApp.
Related Products

Adesilex P10
C2TE
View TDS and specifications

Adesilex P7
C2T
View TDS and specifications

Adesilex P9
C2TE
View TDS and specifications

Adesilex P9 Express
C2FT
View TDS and specifications

Eco Prim Grip Plus
View TDS and specifications

Fugolastic
CG2
View TDS and specifications
All Tile Adhesives and GroutsEvery Mapei product and the distributor page
Ultracare 5 Sides Sealer in the UAE
Tell us the area. We will quote the job.
Lapiz Blue supplies Mapei from Dubai, Abu Dhabi and Sharjah. Send the quantity of Ultracare 5 Sides Sealer you need, or describe the job and we will work it out with you.

