
Mapei Surface TreatmentNo. 43 / 54
Ultracare Multicleaner Technical Data Sheet (TDS)
Mapei surface treatment.
Routine cleaning is where a protected surface quietly gets ruined, and UltraCare Multicleaner is the neutral concentrate that will not do that. Neutral pH is the point of difference: an acid cleaner etches polished natural stone and an alkaline degreaser strips treatments, while this one maintains both treated and untreated ceramic, stone and concrete day after day.
- Everyday cleaning of treated surfaces
- Maintenance of untreated tile and stone
- Concrete and ceramic floors
- Cement traces on acid sensitive polished stone
- High volume facilities management cleaning
Build a list across products and send it once, or ask about Ultracare Multicleaner on WhatsApp now.
- Consumption
- 0.00067 L/m²
- Pack we stock
- 1 l
- Colour
- transparent
Mapei document 11005 · revision 7-2026
About Ultracare Multicleaner
It will also lift traces of cementitious product from acid sensitive surfaces, the safe route on polished marble where UltraCare Acid Cleaner must not go. Yield is the other argument. Diluted one part to 200, a single litre cleans approximately 1500 square metres, so it suits a facilities team maintaining a mall or a tower rather than a one off clean. A transparent liquid in 0.75, 1 and 5 litre packs, stored for three years.
Documentation
Related documentation
Technical data sheet
Revision 7-2026 · 1.3 MB · PDF
Ultracare Multicleaner as the manufacturer publishes it, unaltered.
DownloadSafety data sheet
Needed for a method statement or a site file. Ask and we will send it.
RequestSubmittal pack
Data sheet, safety data sheet and our authorisation letter together, for a consultant submittal.
Request
Coverage calculator
How much you need.
As published in the data sheet
0.03litres
- Diluted 1:200 with water: 0.00067 litre/m2
- over 50 m2
Order 1 pack of 5 litre jerrycan, also 1 litre
Taken from the Ultracare Multicleaner data sheet: CONSUMPTION: diluted in a ratio of 1:200 with water it is possible to clean approximately 1500 m2 of surface area with a litre of UltraCare Multicleaner. No site allowance is added unless you turn one on. The rate is litres of undiluted concentrate per square metre, inverted from the 1500 m2 per litre the sheet publishes at a 1:200 dilution. Consumption varies with the dilution, the degree and type of dirt and the surface, and the sheet publishes no rate for any other dilution.
Application
Where it is used.
- 01Everyday cleaning of treated surfaces
- 02Maintenance of untreated tile and stone
- 03Concrete and ceramic floors
- 04Cement traces on acid sensitive polished stone
- 05High volume facilities management cleaning
Specification
Technical data.
| Coverage | Diluted in a ratio of 1 : 200 with water, it is possible to clean approximately 1500 m² of surface area with a litre of UltraCare Multicleaner. Consumption may vary based on dilution, the degree and type of dirt, and the surface to be treated. |
|---|---|
| Pack size | 1 l, 5 l, 0.75 l |
| Set to light foot traffic | 5 minutes |
| Colours | transparent |
| Consistency | liquid |
| Storage and shelf life | UltraCare Multicleaner, stored in the original packaging, has a storage time of 3 years. |
| Density | 1.00 g/cm³ |
Typical values as Mapei prints them in the data sheet for Ultracare Multicleaner. Manufacturers revise their sheets, so ask us for the current edition before you specify.
On site
Packs, mixing and storage.
We stock
1 l, 5 l, 0.75 l. Other pack sizes can usually be brought in on a project order, so tell us the quantity before you assume what is available.
Storage
UltraCare Multicleaner, stored in the original packaging, has a storage time of 3 years. in unopened packaging, stored dry and out of direct sun. Heat and humidity both shorten it.
For quantity surveyors
BOQ clause.
Supply and apply Ultracare Multicleaner, a surface treatment manufactured by Mapei. Allow 0.00067 L/m2, as published by the manufacturer. Supplied in 1 l, 5 l, 0.75 l. Prepare the substrate and apply strictly in accordance with the manufacturer's current technical data sheet. Rates are for estimating and exclude wastage.
| Product | Ultracare Multicleaner |
|---|---|
| Manufacturer | Mapei |
| Type | Surface Treatment |
| Consumption | 0.00067 L/m2 |
| Pack size | 1 l, 5 l, 0.75 l |
| Set time | 5 minutes |
| Unit of measurement | m2 |
Frequently Asked Questions
As per the TDS: Diluted in a ratio of 1 : 200 with water, it is possible to clean approximately 1500 m² of surface area with a litre of UltraCare Multicleaner. Consumption may vary based on dilution, the degree and type of dirt, and the surface to be treated.
1 l, 5 l, 0.75 l
You can download the official Ultracare Multicleaner technical data sheet as a PDF directly from this page, revision 7-2026, sourced from the manufacturer. For prices and stock in the UAE, contact Lapiz Blue on WhatsApp.
Related Products

Adesilex P10
C2TE
View TDS and specifications

Adesilex P7
C2T
View TDS and specifications

Adesilex P9
C2TE
View TDS and specifications

Adesilex P9 Express
C2FT
View TDS and specifications

Eco Prim Grip Plus
View TDS and specifications

Fugolastic
CG2
View TDS and specifications
All Tile Adhesives and GroutsEvery Mapei product and the distributor page
Ultracare Multicleaner in the UAE
Tell us the area. We will quote the job.
Lapiz Blue supplies Mapei from Dubai, Abu Dhabi and Sharjah. Send the quantity of Ultracare Multicleaner you need, or describe the job and we will work it out with you.

