
Mapei GroutNo. 27 / 54
Mapestone PFS 2 Visco Technical Data Sheet (TDS)
Mapei grout.
Mapestone PFS 2 Visco is the pourable jointing grout of the Mapei Mapestone system for stone and concrete paving driven on by vehicles, and not a tile grout. It is a ready mixed powder in 25 kg bags, gauged with only 3 to 3.5 litres of water into a fluid slurry and spread over damp stone with a rubber rake.
- Grouting joints between slabs and blocks of stone
- Grouting joints between slabs of concrete
- Architectural road surfaces and block-paved roads used by vehicles
- Anchoring the stone by filling the contact surfaces between screed and block
- Re-grouting existing stone paving once the cause of deterioration has been removed
Build a list across products and send it once, or ask about Mapestone PFS 2 Visco on WhatsApp now.
- Pack we stock
- 25 kg
- Colour
- 110 Manhattan, 112 Medium Grey, 113 Cement Grey, 141 Caramel, 143 Terracotta, 295 Dark Grey, 299 Limestone
Mapei document 01171
About Mapestone PFS 2 Visco
The low viscosity is the point: it runs to the bottom of the joint and into the contact faces of the block, taking out the air pockets left when the stone was bedded, so the joint anchors the block instead of just closing it. Joint depth decides whether it is right. Joints must be filled completely and be at least 25 mm deep, poured the same day as the stone, fresh on fresh, over a Mapestone TFB 60 screed.
Documentation
Related documentation
Technical data sheet
1.3 MB · PDF
Mapestone PFS 2 Visco as the manufacturer publishes it, unaltered.
DownloadSafety data sheet
Needed for a method statement or a site file. Ask and we will send it.
RequestSubmittal pack
Data sheet, safety data sheet and our authorisation letter together, for a consultant submittal.
Request
Coverage
How much you need.
As published in the data sheet
Mapei publishes no consumption rate for Mapestone PFS 2 Visco. The sheet says consumption depends on the shape and thickness of the stone and on the width and depth of the joints, and those are a paving layout rather than a rate per square metre. What the sheet does fix is the joint: it must be filled completely and must be at least 25 mm deep, poured the same day the stone is laid. One 25 kg bag takes 3 to 3.5 litres of water. Send us the paving layout, the block size and the joint width and we will work the quantity through with you.
There is no area calculator for Mapestone PFS 2 Visco because the sheet does not publish a rate per square metre. Send us the job and we will work the quantity out with you.
Application
Where it is used.
- 01Grouting joints between slabs and blocks of stone
- 02Grouting joints between slabs of concrete
- 03Architectural road surfaces and block-paved roads used by vehicles
- 04Anchoring the stone by filling the contact surfaces between screed and block
- 05Re-grouting existing stone paving once the cause of deterioration has been removed
Where it is not the right product
- Where the joint meets chemicals or constant water, which calls for an epoxy grout
Drawn from this product's own classification. If your situation is close to one of these, send us the detail and we will specify an alternative.
Specification
Technical data.
- EN 13888 and ISO 13007
| Pack size | 25 kg bags |
|---|---|
| Pot life | apply within 40 minutes of mixing at +20C |
| Colours | 110 Manhattan, 112 Medium Grey, 113 Cement Grey, 141 Caramel, 143 Terracotta, 295 Dark Grey, 299 Limestone |
| Mixing ratio | 3-3.5 litres of water per bag according to the surrounding temperature |
| Application temperature | from +5C to +45C, ambient, substrate and stone |
| Consistency | Powder |
| Storage and shelf life | 12 months stored in a dry place protected from damp |
| Maximum grain size | 2 mm |
| Mixing time | minimum 3 min, mechanically, never by hand |
| Bulk density | approx. 1750 kg/m3 |
| Density of blend | 2200 kg/m3 |
| Ph value | approx. 12 at +23C in a saturated solution |
| Modulus of elasticity | approx. 30 GPa |
| Compressive strength | 15 MPa after 1 day, 45 MPa after 7 days, > 55 MPa after 28 days, EN 1015-11 |
| Flexural strength | 3 MPa after 1 day, 5 MPa after 7 days, > 6 MPa after 28 days, EN 1015-11 |
| Minimum joint depth | 25 mm |
| Set to foot traffic | 12-24 hours |
| Set to vehicle traffic | 7 days at +20C |
Typical values as Mapei prints them in the data sheet for Mapestone PFS 2 Visco. Manufacturers revise their sheets, so ask us for the current edition before you specify.
On site
Packs, mixing and storage.
We stock
25 kg bags. Other pack sizes can usually be brought in on a project order, so tell us the quantity before you assume what is available.
Mixing
3-3.5 litres of water per bag according to the surrounding temperature. Mix mechanically to a uniform lump free consistency, and follow any standing time the data sheet gives before remixing. Do not add extra water to recover workability, which lowers strength.
Working time
apply within 40 minutes of mixing at +20C. Mix only what can be placed inside it. UAE summer temperatures shorten every working time printed on a sheet.
Storage
12 months stored in a dry place protected from damp in unopened packaging, stored dry and out of direct sun. Heat and humidity both shorten it.
For quantity surveyors
BOQ clause.
Supply and apply Mapestone PFS 2 Visco, a grout manufactured by Mapei. Mix at 3-3.5 litres of water per bag according to the surrounding temperature. Supplied in 25 kg bags. Prepare the substrate and apply strictly in accordance with the manufacturer's current technical data sheet. Rates are for estimating and exclude wastage.
| Product | Mapestone PFS 2 Visco |
|---|---|
| Manufacturer | Mapei |
| Type | Grout |
| Pack size | 25 kg bags |
| Mixing ratio | 3-3.5 litres of water per bag according to the surrounding temperature |
| Pot life | apply within 40 minutes of mixing at +20C |
| Unit of measurement | m2 |
Frequently Asked Questions
25 kg bags
You can download the official Mapestone PFS 2 Visco technical data sheet as a PDF directly from this page, sourced from the manufacturer. For prices and stock in the UAE, contact Lapiz Blue on WhatsApp.
Related Products

Adesilex P10
C2TE
View TDS and specifications

Adesilex P7
C2T
View TDS and specifications

Adesilex P9
C2TE
View TDS and specifications

Adesilex P9 Express
C2FT
View TDS and specifications

Eco Prim Grip Plus
View TDS and specifications

Fugolastic
CG2
View TDS and specifications
All Tile Adhesives and GroutsEvery Mapei product and the distributor page
On the van
Tools for this job.

Peygran
Cement Tools
A grouting float packs the joint without voids, and a cleaning float takes the haze off before it hardens.
View the range
Peygran
Spacers
The spacer sets the joint width, which decides the grout grade and how much of it the job takes.
View the range
Keiser
Mixing Applications
Mixing to the same water every time is what keeps the colour even from batch to batch.
View the range
Mapestone PFS 2 Visco in the UAE
Tell us the area. We will quote the job.
Lapiz Blue supplies Mapei from Dubai, Abu Dhabi and Sharjah. Send the quantity of Mapestone PFS 2 Visco you need, or describe the job and we will work it out with you.