
Mapei GroutNo. 28 / 54
Mapestone TFB 60 Technical Data Sheet (TDS)
Mapei grout.
Mapestone TFB 60 is the pre blended bedding mortar of the Mapei Mapestone system, the layer the stone is set into and not the grout that closes the joint, which is Mapestone PFS 2 Visco. It is a 25 kg powder gauged with water alone: about 7 percent for the no slump consistency used under small blocks, brick slips and cobblestones, about 9 percent for the plastic consistency used under slabs and bricks.
- Bedding mortar for architectural natural stone flooring in squares, roads and pavements
- Parking lots, pedestrian crossings, roundabouts and speed humps under vehicle traffic
- Laying small blocks, thin section bricks, brick slips and cobblestones at a no slump consistency
- Laying slabs and bricks at a plastic consistency
- The bedding layer under joints grouted fresh on fresh with Mapestone PFS 2 Visco
Build a list across products and send it once, or ask about Mapestone TFB 60 on WhatsApp now.
- Consumption
- 2 kg/m² per mm
- Pack we stock
- 25 kg
Mapei document 00495 · revision 03-2025
About Mapestone TFB 60
Spread 5 to 7 cm thick in small areas and tamp before it sets. It reaches 60 MPa in compression at 28 days and takes vehicle traffic after 7 days at +20°C, which is what puts it under roundabouts, speed humps and car parks. Minimum application thickness is 40 mm, and above 7 cm the sheet requires 20 to 25 percent of 4 to 8 mm gravel.
Documentation
Related documentation
Technical data sheet
Revision 03-2025 · 2.2 MB · PDF
Mapestone TFB 60 as the manufacturer publishes it, unaltered.
DownloadSafety data sheet
Revision 3-2021 · 0.2 MB · PDF
For the method statement and the site file.
DownloadSubmittal pack
Data sheet, safety data sheet and our authorisation letter together, for a consultant submittal.
Request
Coverage calculator
How much you need.
The sheet states 40 to 70 mm.
As published in the data sheet
6,000kg
- 2 kg/m2 per mm
- 60 mm thick
- over 50 m2
Order 240 packs of 25 kg bag
Taken from the Mapestone TFB 60 data sheet: CONSUMPTION: The consumption of Mapestone TFB 60 is approximately 20 kg/m2 per cm of thickness. The sheet quotes per cm, so the figure is divided by ten to give 2 kg/m2 per mm. No site allowance is added unless you turn one on. The sheet prints a minimum application thickness of 40 mm and no maximum, so the upper bound of 70 mm here is ours, not the manufacturer's: it is the top of the sheet's own instruction to spread a 5 to 7 cm thick layer. Above 7 cm the sheet requires 4 to 8 mm gravel to be added at 20 to 25 percent to give the screed structure, which changes what is being ordered. The 20 kg/m2 per cm is the dry powder, not the mixed mortar: adding the 7 to 9 percent gauging water brings it to about 22 kg, which is the 2200 kg/m3 fresh bulk density the sheet prints.
Application
Where it is used.
- 01Bedding mortar for architectural natural stone flooring in squares, roads and pavements
- 02Parking lots, pedestrian crossings, roundabouts and speed humps under vehicle traffic
- 03Laying small blocks, thin section bricks, brick slips and cobblestones at a no slump consistency
- 04Laying slabs and bricks at a plastic consistency
- 05The bedding layer under joints grouted fresh on fresh with Mapestone PFS 2 Visco
Where it is not the right product
- Where the joint meets chemicals or constant water, which calls for an epoxy grout
Drawn from this product's own classification. If your situation is close to one of these, send us the detail and we will specify an alternative.
Specification
Technical data.
- EN 13888 and ISO 13007
| Pack size | 25 kg bags |
|---|---|
| Application temperature | from +5°C to +45°C, air, substrate and stone |
| Storage and shelf life | 12 months if stored in a dry place protected from damp |
| Type | powder |
| Colour | grey |
| Maximum size of aggregate | 5 mm |
| Ph value | approximately 12 at +20°C in saturated solution |
| Mixing water | 7-9% |
| Mixing time | 3 minutes per bag, mechanically |
| Bulk density of fresh blend | 2200 kg/m3 according to degree of tamping |
| Application thickness | minimum 40 mm |
| Consumption | approximately 20 kg/m2 per cm of thickness |
| Compressive strength | 25 MPa after 1 day, 45 MPa after 7 days, 60 MPa after 28 days, EN 13892/1-2 |
| Flexural strength | 4 MPa after 1 day, 6 MPa after 7 days, more than 8 MPa after 28 days, EN 13892/1-2 |
| Set to foot traffic | 12-24 hours |
| Set to vehicle traffic | 7 days at +20°C |
Typical values as Mapei prints them in the data sheet for Mapestone TFB 60. Manufacturers revise their sheets, so ask us for the current edition before you specify.
On site
Packs, mixing and storage.
We stock
25 kg bags. Other pack sizes can usually be brought in on a project order, so tell us the quantity before you assume what is available.
Storage
12 months if stored in a dry place protected from damp in unopened packaging, stored dry and out of direct sun. Heat and humidity both shorten it.
For quantity surveyors
BOQ clause.
Supply and apply Mapestone TFB 60, a grout manufactured by Mapei. Allow 2 kg/m2 per mm, as published by the manufacturer. Supplied in 25 kg bags. Prepare the substrate and apply strictly in accordance with the manufacturer's current technical data sheet. Rates are for estimating and exclude wastage.
| Product | Mapestone TFB 60 |
|---|---|
| Manufacturer | Mapei |
| Type | Grout |
| Consumption | 2 kg/m2 per mm |
| Pack size | 25 kg bags |
| Unit of measurement | m2 |
Frequently Asked Questions
25 kg bags
You can download the official Mapestone TFB 60 technical data sheet as a PDF directly from this page, revision 03-2025, sourced from the manufacturer. For prices and stock in the UAE, contact Lapiz Blue on WhatsApp.
Related Products

Adesilex P10
C2TE
View TDS and specifications

Adesilex P7
C2T
View TDS and specifications

Adesilex P9
C2TE
View TDS and specifications

Adesilex P9 Express
C2FT
View TDS and specifications

Eco Prim Grip Plus
View TDS and specifications

Fugolastic
CG2
View TDS and specifications
All Tile Adhesives and GroutsEvery Mapei product and the distributor page
On the van
Tools for this job.

Peygran
Cement Tools
A grouting float packs the joint without voids, and a cleaning float takes the haze off before it hardens.
View the range
Peygran
Spacers
The spacer sets the joint width, which decides the grout grade and how much of it the job takes.
View the range
Keiser
Mixing Applications
Mixing to the same water every time is what keeps the colour even from batch to batch.
View the range
Mapestone TFB 60 in the UAE
Tell us the area. We will quote the job.
Lapiz Blue supplies Mapei from Dubai, Abu Dhabi and Sharjah. Send the quantity of Mapestone TFB 60 you need, or describe the job and we will work it out with you.