Weber (Saint-Gobain) logo

Weber plasters and renders, supplied across the UAE by Lapiz Blue

A render is the layer everything else is judged on, and most of what goes wrong with a wall shows up in it. Weber makes the weberpremix range as factory blended plasters and renders that only need water, so the mix is the same on the last wall as on the first, and the webertherm system for insulated facades. Lapiz Blue supplies both across the UAE. Tell us the substrate, the thickness you are building up to and whether the wall is inside or exposed, and we will point you at the right grade and the primer it wants underneath.

Visit Weber (Saint-Gobain) Official Website
Wall in section: block, spatterdash key, base coat render, skim coat
Wall in section: block, spatterdash key, base coat render, skim coat

A render is three coats doing three jobs: a spatterdash to key the block, a base coat for thickness and flatness, and a skim for the finish the paint goes on.

The range. All 9.

Applications and Best-Fit Scenarios

1

Internal wall plaster on blockwork and concrete

2

External render on exposed elevations

3

Skim coats before paint or wallpaper

4

Levelling and making good before a decorative finish

5

Insulated facade build ups using the webertherm system

How to Choose the Right Plaster

1

Start with the substrate, since concrete, blockwork and AAC all take a different grade

2

Check the total thickness you need, because a render is built in coats and each has a stated maximum

3

Inside or outside decides it next, as an external render has to take sun, rain and movement

4

Agree the finish before ordering, since a skim coat and a float finish are different products

5

Ask about the primer, because most failures start with a substrate that was not prepared

Common Mistakes to Avoid

  • Applying a render thicker in one pass than the sheet allows
  • Skipping the primer on a highly absorbent block
  • Working in direct sun on an exposed elevation without protecting the surface
  • Adding water on site beyond the stated mixing ratio to make it easier to spread

What You Can Expect

Availability

Stock held on the common grades, project order on the rest

Coverage

UAE wide supply with GCC export support

Branch Support

Quotations and site coordination from Dubai, Abu Dhabi and Sharjah

Technical Guidance

Help matching the grade to the substrate and the build up

Documentation

Weber data sheets for submittals, on each product page

Frequently Asked Questions

In practice the words are used for the same thing, with plaster usually meaning the internal coat and render the external one. The products differ because an external wall has to take sun, rain and movement, so the grades are not interchangeable.

It depends on how absorbent the substrate is. A dense concrete and a lightweight block behave very differently, and the sheet for each grade states what it needs. Send us the substrate and we will confirm it.

Every grade states a maximum thickness per coat and a total. Going beyond it is the most common reason a render cracks or debonds, so it is worth checking the sheet on this page before you start.

No. The mixing ratio on the sheet is what the stated strength and adhesion are measured at. Extra water weakens it and causes shrinkage cracking.

Specifying a plaster or render?

Send us the substrate, the thickness and whether it is inside or exposed.

Share these details for a quick response:

  • Substrate and its condition
  • Total thickness you are building up to
  • Internal or external, and the finish you want
Chat on WhatsApp